Page 1 of 1

What does it mean

Posted: Fri Jul 23, 2004 9:24 pm
by Dylan
When your computer talks to you when you turn it on and it says "The processor might be damaged or installed improperly, damage [discharge] could be the main battery" and the screen is all black? I flip the switch in the back then turn it on and again and it will work fine, sometimes I have to try several times to get it to start right. Then sometimes the screen will go black and it will do that when the computer is already started and I am playing EQ, browsing the web etc.

Posted: Sat Jul 24, 2004 2:57 pm
by Lueyen
Johnn has it been particularly warm recently? If your machine is overheating it can cause a lot of wierd things to happen. Proccessors are probably the most sensitive to this.

Posted: Sat Jul 24, 2004 3:05 pm
by Dylan
Hmmm, it has been warm due to summer and my computer is down in a hole by itself.. and come to think of it, it only restarts while I was in EQ when I was doing stuff that makes it work hard... should I move it out of where it is to more air? And is it too late to reverse the damage?

Posted: Sat Jul 24, 2004 7:22 pm
by Lueyen
Chances are there is no real damage done save for reducing the lifetime of the components. If it's only happening when your on EQ, there is a good chance that the load on the machine is causing a build up of heat. The message and stuff you are getting is probably a warning threshold to prevent actually damage to the processor (ie burning it up).

Yes, make sure the machine has decent ventalation. Anywhere you have fans, make sure they are not blocked. Another good thing is with the case off turn the machine on and just verify all the fans are actually working. If the problem still persists sometimes running the computer with the side off can help, however this also reduces the effectiveness of the fans due to there being less of a vacum inside the case. I did see it suggested once to try placing a box fan next to the machine with the side off blowing inside of it.... this should definetly keep it cool, and tell you for sure if it's a heat problem, but I wouldn't consider it a permanant fix.

You may just need to keep the room cooler, or add aditional fans, you can get slot fans that plug in like cards that suck air through one of the slots on the back of the machine and blow it up through the case, or bay fans that take up a drive bay slot and pull air in through the front of the case. These are fairly in expensive.

Posted: Mon Jul 26, 2004 2:22 pm
by Dylan
Ok moving it out of its hole and opening the case didn't seem to work so I guess I will try cleaning it out with some compressed air or something.

Posted: Mon Jul 26, 2004 7:04 pm
by Harrison
Yeah dust buildup on your heatsink will cause that.

Compressed air cleaning(for the dust problem), re applying some thermal paste, keep your case open (more dust but better air flow without a nice case with case fans)

Posted: Mon Jul 26, 2004 9:08 pm
by Dylan
What the hell is thermal paste?

Posted: Mon Jul 26, 2004 10:30 pm
by Harrison
...

Posted: Mon Jul 26, 2004 10:32 pm
by Dylan
Quit pretending to be AFK on aim

Posted: Mon Jul 26, 2004 10:37 pm
by DangerPaul
Finawin Darkfyre wrote:keep your case open (more dust but better air flow without a nice case with case fans)


worst advice ever


Cases are designed to be enclosed with fans for a reason, otherwise they would be sold open. Heat disperses in a science type way that I am incapable of explaining, however, keeping the case open actually causes more bad than good.

Posted: Mon Jul 26, 2004 10:42 pm
by Harrison
Cases are designed to be enclosed with fans for a reason


I said without a nice case with fans.

A shitty case with 1 case fan (or /gasp less) sucks balls for heat. Trust me I know this from personal experience.

Posted: Tue Jul 27, 2004 5:31 am
by Lueyen
Johnn of War wrote:What the hell is thermal paste?


It's a paste that you put between your chip and heat sink. It helps draw heat off the chip.

Posted: Tue Jul 27, 2004 3:01 pm
by Dylan
I... see...

Posted: Thu Jul 29, 2004 3:52 am
by Captain Insano
Johnn of War wrote:What the hell is thermal paste?


like KY for computers.

Posted: Thu Aug 05, 2004 1:55 pm
by Dylan
Okay, now that computer doesn't start at all, I can get it to skip the warning message but then it just sits at a black screen and theres no start up "beep"... So looks like I am in the market for a new processor, if I ever figure out which piece is the processor...

Posted: Thu Aug 05, 2004 2:39 pm
by Kelic
Friend of mine's processor burned up cause the heat sink wasn't fitted right and the goo was wiped off by some one. Also, if there's no beeping when you start it up, the problem could be in the BIOS. I'm a novice here with this shit, but I think BIOS is responsible for checking everything before it boots, and it's the one that beeps the error codes. Someone correct me if I'm wrong, now I'm curious too.

Posted: Thu Aug 05, 2004 2:49 pm
by Dylan
Is the processor even something you can go pick up from a store and replace?

Posted: Thu Aug 05, 2004 2:54 pm
by Martrae
Yes, but if you don't know what you are doing I wouldn't recommend it.

Go to your local repair shop and talk to them about fixing it. Probably cost around $60 an hour for them to do it but it should be done right.

Posted: Thu Aug 05, 2004 2:58 pm
by Kelic
Yeah that would be the best way to do it. If ya don't know what yer doin (and I'm speakin from personal experience) stay the hell outta the tower. What you spend on getting it repaired won't be near what you'll have to spend on a new puter after you fuck it up. WOOT! 5 o'clock it's go time. G'luck with your problem though.