Page 1 of 1
CISCO console interface
Posted: Tue Apr 26, 2005 10:53 am
by Tossica
Any CISCO gurus have experience with USB/DB9 serial adapters? I bought one because my laptop doesn't have a serial port on it. I can connect to the console but it doesn't seem to be emulating correctly. CR and several other keys don't work properly.
Posted: Tue Apr 26, 2005 10:59 am
by Lyion
There shouldnt be any change with the adapter going through USB. Do you have your terminal settings setup correctly? What terminal emulation are you using?
It should work in a VT 100 or 220 setting.
Posted: Tue Apr 26, 2005 11:04 am
by Tossica
VT100 emu
I am using SecureCRT term program. The settings are correct AFAIK.
Protocol: serial
Port: COM2
Baud: 9600
Data Bits: 8
Parity: none
Stop Bits: 1
Flow Control: off
Posted: Tue Apr 26, 2005 11:11 am
by Lyion
Maybe try setting your databits to 7? I'd tweak the terminal settings and see if it fixes the problem. I think thats the culprit.
Posted: Tue Apr 26, 2005 11:18 am
by Tossica
I'll fiddle with it a bit more but I might be better off looking in to a PCMCIA serial card or something...